I was wondering if anyone on the forum might have a similar setup (crossover to amplifer), and might offer suggestions:
I am using the crossover (latest version-- with AudioQuest Sky pigtail), Vandersteen 3A Sig speakers and a pair of Vandersteen 2wq subwoofers, along with a pair of monobloc BC 200 series amplifier.
My amplifiers have an input impedance around 200K ohms. However, whenever I set the crossovers over 75K, I get a buzzing sound from one of my speakers. At 75K ohms and below, everything is fine. When I disconnect the subs and crossovers from the system, everything is fine.
Is anyone using anything other than a Vandersteen crossover to connect to a Vandersteen sub?
Thanks, in advance, for any suggestions.
2 posts • Page 1 of 1